Top Hammer Drilling Rigs - Blast Hole Drilling

 

Tamrock Pantera 1500

Inline Drilling Ltd has a large number of Tamrock Drilling Rigs. Three of these are the Top Hammer type rigs used mainly for Blast Hole Production Drilling and Construction type works. Pictured here is the Tamrock Pantera 1500 located at the Mangatini Sump Project, Stockton Open Cut Coal Mine site, New Zealand. 

For any of these services call Glenn 021 855 963

Tamrock Pantera 900

Pictured on the left is the Tamrock Pantera 900. This rig is used to provide small diameter blast hole drilling services to our clients in the Quarrying & Construction Industry. In the past this smaller version of the Tamrock Pantera range has been used for "break in" and Construction type works in both the North & South Islands of New Zealand.

Ingersoll Rand ECM680

The Ingersoll Rand ECM680 Drilling Rig pictured on the left is located at the Stockton Open Cut Coal Mine site near Westport in the South Island of New Zealand. The IR 680 rig is the smallest in the range of Ingersoll Rand (Atlas Copco) drilling rigs that Inline Drilling Ltd operate in New Zealand.

Tamrock Pantera 1100

Inline Drilling Ltd run a Tamrock Pantera 1100 also in the Quarry sector. This slightly larger top hammer unit can provide hole diameters from 89mm to 152mm when required. This unit is currently based in the North Island.